Your source for watching and selling videos
  • Filter Results
  • 5:18

    Basic Maneuvers for Beginner RC Pilots

    Flying aerobatic maneuvers is exciting and part of radio control flying! In this RC hobby video, Bob Snyder teaches some basic maneuvers that you will want to learn before you begin to fly. Watch as he demonstrates the loop, aileron roll and inverted flight maneuvers.

  • 4:51
    How to Land an RC Plane

    How to Land an RC Plane

    Bob Snyder teaches you how to land an RC plane safely and efficiently. Landing your plane is something that needs to be done and in this featured video, Bob provides helpful tips and techniques for making the landing process much easier. Find out how the weather conditions play a role in the landing process and

    Read more »

  • 3:29

    Using a Table Saw Jig to Rip Skinny Pieces of Wood

    For whatever reason, you may want to make skinny pieces of wood even skinnier, but the fence on your table saw doesn’t typically allow you to do so, until now. George Vondriska developed a simple sled jig that you can create using a 10″ board and an old push pad to provide greater control over

    Read more »

  • 5:59

    Cut Dovetail Sockets with a Shop Made Table Saw Dovetail Jig

    Learn a new method of cutting dovetail sockets that utilizes a shop-made table saw jig. Everyone loves the look of dovetails, and they deliver unquestionable strength and durability as a woodworking joint. The approach described by George in this video is a simple, flexible means of producing high quality dovetails using a table saw dovetail

    Read more »

  • 7:43
    Using Horizontal Raised Panel Router Bits

    Using Horizontal Raised Panel Router Bits

    Master the process of building stylish cabinet doors using horizontal raised panel router bits. Raised panel doors contribute an air of distinction to a cabinet, but many woodworkers admit that they are intimidated by the process of building them. Like any process in woodworking, this one can be learned and mastered by following a set

    Read more »

  • 27:41
    End Grain Cutting Board Plans

    End Grain Cutting Board Plans

    In this woodworking project demonstration, George Vondriska teaches you how to build a long-lasting end-grain cutting board that will look and work great in your kitchen. He walks through the cutting board plans step-by-step for building the board from scratch, including wood and pattern selection, initial layout, cut mechanics and finishing.

  • 10:35
    Batteries Volume 8

    Batteries Volume 8

    You’ll learn about some of the available charging options for your RC model’s battery pack. No matter what type of battery you choose to use on your model, there is a charging system that is ideal for the type of flying you plan to do. We warn against making changes to your aircraft’s electronics with

    Read more »

  • 7:48
    Starting a Gas Engine

    Starting a Gas Engine

    Steve Thomas presents the features of an LE55 engine and teaches you how to safely start an RC gas engine. You’ll learn tips on safety and how to start an engine and make sure you get maximum power from it.

  • 3:32
    Miter Gauge Bandsaw Fence

    Miter Gauge Bandsaw Fence

    Here’s a great solution if you’ve been struggling with a resaw fence for your bandsaw. The solution for this problem is probably already in your shop. In this woodworking video, we’ll show you how to make your own bandsaw fence. You’ll find that it’s easy to position and easy to adjust for drift compensation. It

    Read more »